1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Little Engraved Paring Knife

Discussion in 'Fixed Blades' started by PeterP, Apr 14, 2016.

  1. PeterP

    PeterP Active Member

    Likes Received:
    267
    Trophy Points:
    63
    Well seeing that I had not enough metal and scale left over to make a full size hunter or something else, I decided to use what I had left over from my last Clip Point, and made a paring knife.
    I had too ....just had too do some engraving on it now that I have the bug! :p
    Hope you guys enjoy this one.
    Red Malle burl scales
    01 steel
    and some free hand engraving
    Cheers
    [​IMG]
    [​IMG]
     
    poppa bear and bobbybirds like this.
  2. Icho-

    Icho- Staff Member

    Likes Received:
    152
    Trophy Points:
    63
    So I see you are not only addicted to knifemaking but also engraving. What's next... engraving 36 inch swards? Lol

    Looks great!
     
  3. krash-bang

    krash-bang Active Member

    Likes Received:
    72
    Trophy Points:
    28
    That's one nice little knife Peter! Your engraving skills are getting better and better with each new knife. Nice work!
     
  4. PeterP

    PeterP Active Member

    Likes Received:
    267
    Trophy Points:
    63
    Lol Thanks, actually was thinking smaller like Bowie knife! ;)
     
  5. PeterP

    PeterP Active Member

    Likes Received:
    267
    Trophy Points:
    63
    Thank you Krash!
     
  6. dancom

    dancom Dust Maker Best Shop Tool

    Likes Received:
    1,128
    Trophy Points:
    113
    I like it!
     
    PeterP likes this.
  7. PeterP

    PeterP Active Member

    Likes Received:
    267
    Trophy Points:
    63
    Thank you Dan
     
  8. bob682

    bob682 New Member

    Likes Received:
    21
    Trophy Points:
    8
    your engraving is really good!1 what do you use?
     
  9. PeterP

    PeterP Active Member

    Likes Received:
    267
    Trophy Points:
    63
    Thank you Bob, I use a dremel.
    Don't have the funds to get a real engraving kit yet.
     
  10. bob682

    bob682 New Member

    Likes Received:
    21
    Trophy Points:
    8
    mind to tell me what kind of bit you use? i tried a doodle the other day and could barely get a scratch on the surface
     
  11. PeterP

    PeterP Active Member

    Likes Received:
    267
    Trophy Points:
    63
    Diamond tips....Canadian tire has them.
     
  12. PeterP

    PeterP Active Member

    Likes Received:
    267
    Trophy Points:
    63

Share This Page