1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Kith Build

Discussion in '2016 KITH' started by LeclairKnives, Apr 17, 2016.

  1. LeclairKnives

    LeclairKnives Active Member

    Likes Received:
    147
    Trophy Points:
    43
    Hey guys, here is my kith entry [​IMG]
    It will be one of the two of these still haven't decided.
    Top one is cpms30v it has a 3.5" blade and 4" handle
    Bottom one is 154cm and has a 3" blade and 4" handle.
     
    dancom likes this.
  2. Icho-

    Icho- Staff Member

    Likes Received:
    154
    Trophy Points:
    63
    Both are a good pattern for a bird and trout knife. If I had to pick I would go with the bottom one.
     
    LeclairKnives likes this.
  3. SDMay

    SDMay Active Member

    Likes Received:
    77
    Trophy Points:
    28
    Both look really good.
     
    LeclairKnives likes this.
  4. Mythtaken

    Mythtaken Staff Member CKM Staff

    Likes Received:
    275
    Trophy Points:
    83
    I like both. The bottom one has a little more "style" but either looks like a good tool.
     
  5. bobbybirds

    bobbybirds Active Member

    Likes Received:
    171
    Trophy Points:
    43
    Nice man! I too think I have a preference to the bottom. Being slightly smaller will make it a bit more usefully for its intended job I would think...
     
  6. LeclairKnives

    LeclairKnives Active Member

    Likes Received:
    147
    Trophy Points:
    43
    Hey guys I really wanted to do a wip on this knife but have been sooo busy with spring house work and knife orders I just didn't get to it. Here is the knife.
    CPM S30V paring knife. 7.25" overall with a 3.5" blade. The handle is some amber dyed bone with stainless pins.
    [​IMG]
    Thanks for looking
    StaySharp
     
    John Noon and bobbybirds like this.
  7. bobbybirds

    bobbybirds Active Member

    Likes Received:
    171
    Trophy Points:
    43
    Nice knife man!
     
    LeclairKnives likes this.
  8. dancom

    dancom Dust Maker Legend Member

    Likes Received:
    1,216
    Trophy Points:
    113
    Looking good! S30V stainless to boot. Did Ed heat treat that for you?
     
  9. LeclairKnives

    LeclairKnives Active Member

    Likes Received:
    147
    Trophy Points:
    43
    Thanks Dan. I just happened to have a scrap piece from a kitchen knife that was big enough so that's what I used. Yes I had it treated by Ed.
     

Share This Page