1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Polishing Jig For Bench Grinder

Discussion in 'Jigs & Holders' started by poppa bear, Feb 12, 2016.

  1. poppa bear

    poppa bear Member

    Likes Received:
    21
    Trophy Points:
    18
    OK so I figured this out from my latest project upsetting me as I was buffing it.

    If your using a bench grinder as I am for your grinding needs also buffing here's a trick. With the shelf up on the buffing wheel no matter if you have a 6-10 inch grinder take a small 1/4-1/2 once by 3 inch long chink of flat wood, C clamp it to the shelf so it's just about 3mm from the wheel, and start your buffing and or grinding. This saves the blade edge and also allows you to have a stable place for your knife without worry of scratches to your finish.

    Pb
     
  2. John Noon

    John Noon Well-Known Member

    Likes Received:
    542
    Trophy Points:
    113
  3. poppa bear

    poppa bear Member

    Likes Received:
    21
    Trophy Points:
    18
    :beer::)Thanks but that maybe next month John
     

Share This Page